Barra de espaço
Barra de espaço

This tutorial presents a detailed procedure demonstrating how to perform the configuration of a virtual interface on a Cisco Catalyst 2960 switch. 

YOUTUBE

In our channel you can view the video of this tutorial.



EQUIPMENT LIST

The link below shows a list of the network equipment that I used to implement my network project:

 EQUIPMENT LIST

This link will also show the software that I used to implement my network project.

 

PLAYLIST

The link below shows a playlist with Cisco switch tutorials.

 PLAYLIST



TUTORIAL

Access the console of your cisco switch and enter the following commands to create a vlan.

# configure terminal
# vlan 10
# name SERVIDORES
# exit


Enter the configuration mode and create a virtual interface through the command below.

# configure terminal 
# interface vlan10
# ip address 192.168.10.10 255.255.255.0
# no shutdown


Check if the interface is online through the command below..

# show interface vlan 10

 
In our example, we created the interface vlan 10 with the IP address 192.168.10.10.

Save your configuration via the command below.

# copy running-config startup-config

 

The amount of allowed virtual interfaces is limited by the version of the IOS operating system.

For the interface vlan 10 go online you may need to turn off other virtual interfaces. (vlan 1)

 CONCLUSION

This tutorial presented the process of setting up a virtual interface on a Cisco Catalyst 2960 switch.