Barra de espaço
Barra de espaço

This tutorial describes a detailed procedure showing how to configure TRUNK on a Cisco Catalyst 2960 switch.

YOUTUBE

In our channel you can view the video of this tutorial.



EQUIPMENT LIST

The link below shows a list of the network equipment that I used to implement my network project:

 EQUIPMENT LIST

This link will also show the software that I used to implement my network project.

 

PLAYLIST

The link below shows a playlist with Cisco switch tutorials.

 PLAYLIST



TUTORIAL

Access the console of your Cisco switch and enter the following commands to configure the VLANs 100 and 200.

# configure terminal
# vlan 100
# name VOIP-NETWORK
# vlan 200
# name DATA-NETWORK
# exit

 

Note! Change the VLAN ID and its name to reflect your environment.

Save your configuration via the command below

# copy running-config startup-config


Configure a switch interface as trunk through the commands below.

# configure terminal 
# default interface gigabitethernet0/24
# interface gigabitethernet0/24
# switchport mode trunk
# switchport trunk native vlan 1
# exit

 

Nota! Use the default interface command to reset the factory settings of an interface.

Save your configuration via the command below

# copy running-config startup-config

 

 CONCLUSION

This tutorial presented the TRUNK configuration for a Cisco Catalyst 2960 switch.